Troubleshooting appendix b – Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL User Manual
Page 413
Troubleshooting
Appendix B
B-8
Problem
What to do
Cause
ББББББББББББ
Б
ББББББББББ
Б
Б
ББББББББББ
Б
Б
ББББББББББ
Б
Б
ББББББББББ
Б
While trying to download an application file,
a PROBLEM window appears stating: Error
code 208 was returned by the PassĆThrough
Utility."
ББББББББББББ
Б
ББББББББББ
Б
Б
ББББББББББ
Б
Б
ББББББББББ
Б
Б
ББББББББББ
Б
The PassĆThrough Utility has been unable to
establish DH+ communications with the PLCĆ5.
ББББББББББББ
Б
ББББББББББ
Б
Б
ББББББББББ
Б
Б
ББББББББББ
Б
Б
ББББББББББ
Б
Make sure the Programming Terminal DH+
Address" and the PLC DH+ Address" are
properly assigned.
Make sure that you have selected the proper
DH+ Hardware Driver" for your system, and that
the DH+ Driver Card Location" code is correct.
ББББББББББББ
Б
ББББББББББ
Б
Б
ББББББББББ
Б
Б
ББББББББББ
Б
Immediately after completing a PLCĆ5
PassĆThrough Download, a Minor Fault
Status bit is set in the PLCĆ5.
ББББББББББББ
Б
ББББББББББ
Б
Б
ББББББББББ
Б
Б
ББББББББББ
Б
The rack assignment configuration of the
application file downloaded to the PanelView did
not exactly match the application file that was
overwritten.
ББББББББББББ
Б
ББББББББББ
Б
Б
ББББББББББ
Б
Б
ББББББББББ
Б
Use the PLCĆ5 6200 Series software to clear the
Minor Fault; then reconfigure the PLCĆ5 to
recognize the new rack assignment.
Table B.G
PLC Series/Revision Requirements for PassĆThrough File Transfer
Processor
Series
Revision
PLCĆ5/11
All
All
PLCĆ5/15
B
N or later
PLCĆ5/20
All
All
PLCĆ5/25
A
J or later
PLCĆ5/30
A
B or later
PLCĆ5/40
A
B
E or later
B or later
PLCĆ5/60
A
B
E or later
B or later
PLCĆ5/250
All
All