Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL - Manual (Page 206)

File Operations
Chapter 6
6-32
To convert an application file into two hex files which can later be
retrieved or sent to the EPROM burner, choose Generate Hex Files. The
two files that are created correspond to “User Mem High Byte (U52)” and
“User Mem Low Byte (U53)” and have the file extensions .U52 and .U53.
To send previously generated Hex files, choose Select Hex File. The Hex
files will be loaded and the Burn FILENAME menu will appear as it does
when using the Select Application File option.
Burn Single EPROM
To burn a single EPROM for Series D or E terminals, choose Burn Single
EPROM from the Transfer menu. Then, choose Select Application File to
select the file you will download to the EPROM burner. After you press
Enter, PanelBuilder takes a few seconds to generate the hex file. When the
file is created, the Burn FILENAME menu opens, (where FILENAME is
the name of the application file you selected).
The file must have been created with the User Memory Limit set to one of
the smaller selections (59,904 or 62,976).
Figure 6.30
The Transfer Menu and Burn Single EPROM Menu
23625
MAIN MENU: Screens Windows Options Communicup Exit Transfer
Download to PanelView (RS-232)
Upload from PanelView (RS-232)
Pass-Through Download to PanelView (DH+ and Remote I/O)
Pass-Through Upload from PanelView (DH+ and Remote I/O)
Burn EPROMS
Burn Single EPROM
Quit
Burn Single EPROM
Select Application File EXAMPLE
Select Hex File EXAMPLE
Generate Hex Files EXAMPLE
Directory
Quit
Burn EXAMPLE
Send User Memory [U2]
Configure Port COM1
Application Size
Quit
Send User Memory [U2] sends the data for the EPROM chip U2 to the
EPROM burner.