Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL - Manual (Page 195)

File Operations
Chapter 6
6-21
Figure 6.20
Local Bridge Address and Remote Bridge Address Selection
22571
Local Bridge Address Remote Bridge Address
Not Used
Bridge Address (0-376)
Quit
Not Used
Bridge Address (0-77)
Quit
Configuring the PanelView Terminal for Pass-Through
The Auto-Restart After Download parameter can be configured at the
PanelView terminal.
Set the terminal’s Mode Select Keyswitch to Configure. From the
Configuration Mode Menu, choose Pass-Through Download Options. A
window will open, slightly different on a touch screen terminal than on a
keypad terminal.
Figure 6.21
The PassĆThrough Download Options Window (Keypad Terminal)
23663
PASS-THROUGH
DOWNLOAD OPTIONS
>Auto Restart
Address Source
PLC Type
Baud Rate
Rack Number
Module Group
High/Low Byte
Up
Cursor
Save &
Exit
Manual
Address
Source
Down
Cursor
Change
Data
Yes
Application
PLCĆ5/30
115.2K
7
4
High
If you choose Yes for Auto-Restart, PanelView will start executing the new
application file as soon as the download is completed. If you choose No,
PanelView will wait for operator confirmation before starting to execute
the new application.
The rack assignments and PLC status will remain as per the previous
application file until the moment the new application begins executing.