Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL - Manual (Page 27)

Introduction to PanelBuilder
Chapter 1
1-13
PLCĆ2 Family Processors via 1771ĆSN or 1772ĆSD2
This includes the PLC-2/05, 2/15, 2/30, 2/40, etc. One or more PanelView
terminals can be connected to these processors along with other I/O racks
via the 1771-SN I/O Subscanner Module.
If you are using a 1772-SD2 Scanner /Distribution panel, you must use
revision 3 or later.
SLC 5/02 via 1747ĆSN
One or more PanelViews can be connected to the 1747-SN I/O Subscanner
Module (SLC 500 RIO connection) for the SLC 5/02 processor. Each
module provides an additional remote I/O link for the host programmable
controller. The rack range of the 1747-SN is 0 to 3.
IMPORTANT: With the SLC 5/02 and 1747-SN module, no block
transfers are possible.
1771ĆSN I/O Subscanner Module
One or more 1771-SN I/O Subscanner Modules can be installed in any
standard Allen-Bradley 1771 I/O rack. Each module provides an additional
remote I/O link for the host programmable controller. One or more
PanelView terminals can be connected to any of the previously mentioned
processors along with other I/O racks via a 1771-SN I/O Subscanner
Module. Refer to the 1771-SN Sub I/O Scanner Module Data Sheet for
specific details.
6008ĆSI IBM PC I/O Scanner
This module can be installed in an IBM PC or compatible computer to
provide the computer with an Allen-Bradley 1771 Remote I/O Link. You
can then connect Allen-Bradley Remote I/O racks and devices such as the
PanelView terminal to this computer.
6008ĆSV VME I/O Scanner
This module can be installed in a VME backplane, providing the VME
controller with an Allen-Bradley 1771 Remote I/O Link. Allen-Bradley
Remote I/O racks and devices such as the PanelView terminal can then be
connected to this VME controller.