The objects chapter 10 – Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL User Manual
Page 301
The Objects
Chapter 10
10-36
Table 10.L
Fixed Position Decimal Point
Digits Entered
Keypad Control Address
Value
Number Displayed
ББББББББ
ББББББББ
1
ББББББББ
ББББББББ
100
ББББББББ
ББББББББ
.1
ББББББББ
ББББББББ
12
ББББББББ
ББББББББ
120
ББББББББ
ББББББББ
.12
ББББББББ
ББББББББ
123
ББББББББ
ББББББББ
123
ББББББББ
ББББББББ
.123
ББББББББ
ББББББББ
1234
ББББББББ
ББББББББ
1234
ББББББББ
ББББББББ
1.234
ББББББББ
ББББББББ
12345
ББББББББ
ББББББББ
12345
ББББББББ
ББББББББ
12.345
PLC Controlled allows the PLC controller to set the number of digits
to be displayed after the decimal point.
If you choose the PLC controlled decimal point, assign a Decimal Point
Position Address, a PLC input or output address. This three-bit binary
code indicates the number of digits to the right of the decimal.
For example, a value of zero (000 binary) means that there will be no
digits displayed after the decimal point (and the decimal itself will not
be displayed); a value of three (011 binary) means there will be three
digits to the right of the decimal point; a value of seven (111 binary)
means that seven digits will be displayed to the right of the decimal
point. The remaining bits in the word address can be assigned to other
functions.
Decimal Key Controlled allows the operator to enter the number and
decimal point. The terminal interprets the decimal point position in the
window and sets the Decimal Point Position Address to that value.
Table 10.M
Decimal Key Controlled Decimal Position
Digits Entered
Keypad Control
Address Value
Decimal Point
Position Address
Value
Number Displayed
ББББББ
ББББББ
123
ББББББ
ББББББ
123
БББББББ
БББББББ
0
ББББББ
ББББББ
123
ББББББ
ББББББ
1.23
ББББББ
ББББББ
123
БББББББ
БББББББ
2
ББББББ
ББББББ
1.23
ББББББ
ББББББ
.12345
ББББББ
ББББББ
12345
БББББББ
БББББББ
5
ББББББ
ББББББ
.12345
To send a decimal point value to the PLC controller, define a Decimal
Point Position Address. In this case, only a PLC input can be used. The
three-bit value stored at this address determines the number of digits to
the right of the decimal point. The relationship between the number and
decimal point is implied; the number sent to the PLC controller does not
contain a decimal point.