Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL - Manual (Page 249)

Information and Alarm Windows
Chapter 7
7-41
Downloading an application to the terminal resets the Alarm Status
information. The Alarm Status Reset Time/Date Stamp shows the date and
time of the download completion. How the application is configured also
affects the Time/Date Stamp:
For applications configured to retain Alarm Status information, the
Time/Date stamp is retained between power cycles.
If the application is not configured to retain Alarm Status Information,
the Time/Date stamp is reset to show the time and date of power-up.
Alarm Status Screen Buttons
Change Mode allows you to choose from three ways of viewing the
screen: viewing all alarms (All Messages), active alarms only (Active
Alarms) and previous alarms (Past Alarms).
Reset Qty/Time (if enabled) resets the Qty (alarm count) field to 0, and
the Accum Time (accumulated time in-alarm) field to 00:00:00. If you
press this button, you will be prompted for confirmation before the
values are actually reset.
IMPORTANT: The Alarm Quantity and Accumulated Time counts can
be reset from the Alarm Status Screen and from the PLC controller,
depending on your choices when configuring the Alarm Status screen.
Print Status prints out the alarm status (all alarm messages, active
alarms or previous alarms, depending on the screen mode). You will be
prompted for confirmation before printing begins.
History opens the Alarm History screen.
Page Up displays the previous page of alarms.
Page Down displays the following page of alarms.
Line Down scrolls to the first message of the next page (unless there are
no following messages).
EXIT returns you to the Alarm History screen.
Viewing the Display
Choosing Change Mode brings up the Change Mode To Display selection
of three buttons. Choose one of the three display modes.