Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL - Manual (Page 29)

Chapter
2
2-1
Installing PanelBuilder
This chapter includes information on:
PanelBuilder’s hardware and software requirements
how to install and start up PanelBuilder
the compatibility of older versions of PanelView terminals with
applications created by the current release of PanelBuilder
PanelBuilder requires DOS 3.0 or above.
PanelBuilder Development Software requires one of the following
computers:
Allen-Bradley 1784 series industrial terminals and laptop computers
Allen-Bradley 6120 series industrial computers and 6160 series
industrial workstations
IBM XT

, AT

, PS/2

or 100% compatible
In addition your system must have:
one of the following video adapters and appropriate monitors:
Standard Monochrome Adapter
Hercules

Graphics Card
Color Graphics Adapter (CGA

)
Enhanced Graphics Adapter (EGA

)
Video Graphics Array (VGA

)
Screens for all terminals can be created using either a monochrome or
color monitor.
at least 640K of RAM
a floppy drive capable of reading the disks
Software Requirements
Hardware Requirements