Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL - Manual (Page 259)

PLC Controlled Options
Chapter 9
9-2
Figure 9.1
Address and Communications Options for PLC Controlled Alarm Relay
FILE MENU: Screens Windows Options Communications Exit
21152
Options
Display Menus for Terminal Version
PanelView Display Type
User Memory Limit
Minimum Push Button on Time
Cursor Auto-Repeat Rate (per Sec.)
Cursor Auto-Repeat Start Delay
Time and Date to PLC Controller
Current Screen Number to PLC Controller
Screen Print Active to PLC Controller
PLC Controlled Audio
PLC Controlled Alarm Relay
PLC Controlled Screen Number
PLC Controlled Screen Print
PLC Controlled Time & Date
Configure Pass-Through Download Bits
Quit
5
Color
62,976
50 msec
1
400 msec
Disabled
Enabled
Disabled
Enabled
Disabled
Disabled
Disabled
Enabled
PLC Controlled Alarm Relay
Current Address Unassigned Address
Current Preset
Data Type Bit
Communications Discrete
Input/Output Input
Rack 1
Start Word 0
Start Bit 0
Number of Bits 1
Update Address
Change Preset
View Address Map
Delete Address
Quit
You must define the following items to assign a PLC address. Figure 9.1
shows a typical address menu used for PLC controlled options.
IMPORTANT: First enter the settings described below. Then choose
Update Address, or the settings you have entered will be lost.
Current Address and Current Preset indicate the current address and
the preset values for the feature. These fields cannot be edited. The
value displayed is based on other settings entered.
Data Type allows you to define the data type for the option. Valid data
types will vary depending on which control option you are defining.
Communications specifies whether you want a Discrete or Block
Transfer. If you select Block Transfer the Rack option below changes to
File.
Assigning Addresses