Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL - Manual (Page 41)

Using PanelBuilder
Chapter 3
3-5
Pg Up moves the cursor or object diagonally up and to the right. If you are
sizing an object, this key will increase the width and decrease the height of
the object.
Pg Up also draws or erases a diagonal line segment up and to the right.
Pg Down moves the object, or cursor, diagonally down and to the right. If
you are sizing an object, this key increases the width and height of the
object.
Pg Down also draws or erases a diagonal line segment down and to the
right.
Home moves the object or cursor diagonally up and to the left. If you are
sizing an object, this key decreases the width and height of the object.
The Home key also draws and erases a diagonal line segment up and to the
left.
End moves the object or cursor diagonally down and to the left. If you are
sizing an object, the End key decreases the object’s width and increases its
height.
The End key also draws and erases a diagonal line segment down and to
the left.
Ctrl Right moves the cursor to the next text string when editing display
text.
Ctrl Left moves the cursor to the previous text string when editing display
text.
Press the Ctrl or the Alt key to use the alternate character set for typing
object text. The set is illustrated in Appendix E, The Extended Character
Set.
The F3 key identifies the object being edited by causing it to blink.
Pg Up
Pg Dn
Esc
Home
Esc
End
Ctrl
+
³
Ctrl +
²
Ctrl Alt
or
F3