Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL - Manual (Page 355)

The Objects
Chapter 10
10-90
Fill Left with—This option allows you to specify the fill character for
the numeric display. “Spaces” is the default. Your other choice is
“Zeroes”.
If you choose a Numeric Data Display with Decimal Point, the Format
menu also lets you specify how the decimal point is to be handled.
Fixed Position—This option lets you fix the decimal point for the
Numeric Data objects in the Object List. For this option, enter the
number of digits you want after the decimal. The maximum that you can
enter depends on the Number of Digits specified, and the width of the
Object List.
PLC Controlled—This option lets you assign the control of the decimal
point to the PLC. If you select this option, you should also set the
Decimal Point Position Address from the Address Menu.
If you choose a Scaled Numeric Data Display Object List, the Format
menu allows you to specify the Scaling Factor, Offset Value, and how to
display the results.
Scaling Factor—This option lets you define how much you want the
displayed value to be scaled. The valid range is from .0001 to 9999.
Offset Value—This option lets you define how much you want the
amount of the value to be offset. The range is from –32768 to 32767.
Display Results with—This option lets you define whether you want
the data displayed with a decimal point, or rounded off to the nearest
whole number.
States and Text
The States & Text menu is a Multi-State Indicator Object List menu. It
allows you to define up to 16 states, and define the text and display
attributes for each state.
The menus and sub-menus are identical to those of a single Multi-State
Indicator object, except that how you define the state text information for
the 16 states will apply to all Multi-State Indicators in the Object List. The
Character Height option in the State menu applies to all Multi-State
Indicators in the Object List, and also affects the total height or size of the
entire Object List.
Character Height—This option lets you set the characters to single or
double height. If you change the attributes of a state by changing the
Character Height of the text, you affect the height of the Object List.