Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL - Manual (Page 40)

Using PanelBuilder
Chapter 3
3-4
Shift Tab or Shift Left moves the object, or cursor, eight columns to the
left.
Shift Up moves the object, or cursor, two rows up.
Shift Down moves the object, or cursor, two rows down.
Shift Home moves the object or cursor diagonally two rows up and eight
columns to the left.
Shift End moves the object or cursor diagonally two rows down and eight
columns to the left.
Shift Pg Up moves the object or cursor diagonally two rows up and eight
columns to the right.
Shift Pg Dn moves the object or cursor two rows down and eight columns
to the right.
The Right arrow key moves the cursor, or the object, to the right. It also
draws or erases a horizontal line segment to the right. If you are setting the
size of an object, the Right arrow makes it larger.
The Left arrow key moves the cursor, or the object, to the left. It also
draws and erases a horizontal line segment to the left. If you are setting the
size of an object, the Left arrow makes it smaller.
The Up arrow moves the cursor or object upwards. It also draws or erases
a vertical line segment upwards. If you are setting the size of an object,
pressing the Up arrow makes it smaller.
The Down arrow moves the cursor, or the object, downwards. It also draws
or erases a vertical line segment downwards. If you are setting the size of
an object, pressing the Down arrow makes it larger.
Shift
+ ¹
Shift
+
²
Shift
+ ↑
Shift
+ ↓
Shift
+ Home
Shift
+
End
Shift
+
Pg Up
Shift +
Pg Dn
³
²
↑
↓