Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL - Manual (Page 265)

PLC Controlled Options
Chapter 9
9-8
Table 9.B
Time and Date Address Format
ББББББ
ББББББ
Word
ББББ
ББББ
1
БББББББББ
БББББББББ
Year (2 or 4 digits)
БББББББ
БББББББ
92-99, 00-25 (2 digit)
or 1992-2025 (4 digit)
ББББББ
ББББББ
Word ББББ
ББББ
2 БББББББББ
БББББББББ
Month БББББББ
БББББББ
1-12
ББББББ
ББББББ
Word ББББ
ББББ
3 БББББББББ
БББББББББ
Day of month БББББББ
БББББББ
1-31
ББББББ
ББББББ
Word ББББ
ББББ
4 БББББББББ
БББББББББ
Hours in 24Ćhour (military) format БББББББ
БББББББ
0-23
ББББББ
ББББББ
Word
ББББ
ББББ
5
БББББББББ
БББББББББ
Minutes
БББББББ
БББББББ
0-59
ББББББ
ББББББ
Word
ББББ
ББББ
6
БББББББББ
БББББББББ
Seconds
БББББББ
БББББББ
0-59
Data Type can be BCD or Binary (default)
Number of Words must be 6
Start Bit must be 0
If an error is detected in the data received from the programmable
controller, the data will be discarded and the following message will be
displayed.
Figure 9.3
Minor Fault Message: PLC Controlled Time and Date
23628
MINOR FAULT: Time/Date received from PLC is invalid
Clear
F8
You can also enable several PanelBuilder options that allow the PLC
controller to process alarms. These are discussed in Chapter 7, Information
and Alarm Windows.
Four PLC controlled options (Clear Window to PLC Controller, Silence
Alarm to PLC Controller, PLC Controlled Clear Windows and PLC
Controlled Silence Alarms) appear under the section Remote Alarm
Window Processing.
A further option, the Alarm Quantity/Accum Time Reset, is explained
under the heading of The Alarm Status Screen.
Other PLC Controlled Options