Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL - Manual (Page 344)

The Objects
Chapter 10
10-79
Figure 10.22
Sample Scrolling List Screen
23715
"
"
"
"
"
"
"
"
"
"
"
Cursor List Object
OBJECT MENU: List Look Outertext Format Address Utility Exit
Down
Up
Cursor List
Object List
Cursor List Buttons
ENTER
IMPORTANT: The Scrolling List is a retentive object. Your PanelView
terminal will retain the current value for the Cursor List and Object List
settings even after you’ve turned the terminal off, or switched to
Configuration mode and back to Run mode. You can enter preset values
for this object.
Please turn to Appendix A for a Scrolling List object example. This
example defines a Scrolling List object that allows you to monitor and
control the operations of an automobile luxury option assembly operation.
It also includes PLC programming suggestions.
Cursor List
In the Cursor List you define all the buttons associated with the Scrolling
List, as well as the List’s cursor display area.
You can enable, disable, move, and change the text for each button in the
list. When you create a Cursor List, you see the object illustrated in the
following figure. Only the Up and Down cursor buttons appear, because
these two buttons are enabled by default. The other buttons are disabled by
default. Note that the text shown for the buttons is not fixed.