Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL User Manual
Page 210
Advertising
Information and Alarm Windows
Chapter 7
7-2
The window appears in the bottom four lines of the screen until either:
the
window’s
Clear
button is pressed, or
the PLC controller instructs PanelView to clear the window by setting
the window control address value back to zero
Figure 7.2
Information Window
20224
Information Window Message 1
Clear
F8
If the Information window is on-screen at the moment when an alarm
occurs, the Alarm window may overlap the Information window. The
Information window will remain after the Alarm window is cleared.
Configuring the Information Window
To configure the Information window, set the Information Window to
Enable in the Windows menu. The Information window menu opens for
you to define the required parameters.
Advertising