Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL - Manual (Page 197)

File Operations
Chapter 6
6-23
Rack Number: 1
Module Group: 0
High/Low Byte: Low
When you set the Address Source to Manual and choose Save & Exit,
the terminal validates the Manual Address Source and saves the
Pass-Through rack assignment setting and that of Auto-Restart. The
terminal also invalidates the existing application file to ensure that the
new manual Pass-Through rack assignment does not conflict with
existing application file rack assignments.
Downloading over the Data Highway +
To download using the PLC Pass-Through feature, both the PLC and
PanelView must be active on the network and in RUN mode. However,
PanelView ignores all operator and PLC inputs and outputs during the
download. The rack assignments and PLC status will remain as per the
previous application file until the download is complete.
Open the Transfer menu and choose Pass-Through Download to
PanelView (DH+ and Remote I/O).
Figure 6.22
Transfer Menu
22558
Transfer
Download to PanelView (RS-232)
Upload from PanelView (RS-232)
Pass-Through Download to PanelView (DH+ and Remote I/O)
Pass-Through Upload from PanelView (DH+ and Remote I/O)
Burn EPROMS
Burn Single EPROM
Quit
Then use the following menu to select the file and initiate the download.