Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL - Manual (Page 309)

The Objects
Chapter 10
10-44
Numeric Input configures the way numbers are entered into the
Numeric Input Cursor Point from the keypad, and sent to the PLC
controller. The Numeric Input address menu has the following items:
Auto-Repeat Rate (per Sec.)—Enter a time number between 0
and 20. If you use the Raise and Lower buttons for editing values
in Numeric Input Cursor Points, this number specifies how many
times per second the values will change when the Raise or Lower
button is held down. The default is 0 times per second.
Auto-Repeat Start Delay—Choose a time value from the list (200
milliseconds to 2.5 seconds). If the Raise or Lower button is held
down, this is the length of time before the value in the Numeric
Input Cursor Point will start to change. The default is 400 msec.
Amount per Increment/Decrement—This value is the amount
the value in the Numeric Input Cursor point will change each time
the Raise or Lower button is pressed. The default is 1.
Range with Decimal Point Enabled Range with Decimal Point Disabled
0.0000001 to 10,000 1 to 10,000
If the Raise or Lower button is pressed for more than the time
specified by the button’s Auto-Repeat Start Delay, the value
automatically increases by the amount specified by the Amount
per Increment/Decrement at the rate specified by the Auto-Repeat
Rate. Auto-repeat is disabled if the rate is set to 0.
Maximum Value—99,999,999 is the largest value that can be
entered in the Numeric Input Cursor Point. The default is
99,999,999.
Range with Decimal Point Enabled Range with Decimal Point Disabled
0.0000001 to 99,999,999 1 to 99,999,999
Minimum Value—99,999,998 is the highest value that can be
entered in the Numeric Input Cursor Point. The default is 0.
Range with Decimal Point Enabled Range with Decimal Point Disabled
0.0000000 to 99,999,998 0 to 99,999,998
IMPORTANT: If you change any of the above Numeric Input Cursor
Point default settings, the application will only be compatible with Version
2 or later PanelView firmware. If you configure a decimal point for your
Minimum and Maximum values, the application will only be compatible
with Version 4 and later firmware.