Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL - Manual (Page 386)

PLC Programming Considerations
Appendix A
A-22
a pump connected to the output module
a pressure gauge connected to the input module
a color Keypad PanelView terminal
Figure A.11
Hardware Programming Example
5/02 Processor
RIO Scanner
БББ
БББ
БББ
PanelView Operator Terminal
Pump
Pressure Gauge
output module
analog input module
As shown in the G file, which follows, the PanelView terminal is
configured as a one and three quarter device beginning at rack 2,
starting group 0. The scanner addresses the PanelView terminal as if it
were two devices, one full rack and another three quarter rack.