Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL - Manual (Page 202)

File Operations
Chapter 6
6-28
Figure 6.26
The Load PanelView Location Data Window
22585
Load PanelView Location Data
Select Application File No File Selected
Application File Comment
Select Directory C: \PDS
Quit
Select Application File produces a pop-up file selection list.
Application File Comment displays the comment for the selected
file.
Select Directory allows you to enter a new directory path to the
application file.
IMPORTANT: This directory applies only to the application file selected.
It does not change the default directory, i.e., the one specified in the Files
menu.
PanelView Location Data extracts the block transfer control address
and the DH+ addressing of the target PanelView from the application
file selected and places them in the PanelView Location Data fields.
Programming Terminal Configuration is the same as for
downloading.
Quit cancels the file operation.
ATTENTION: Incorrect address selection could corrupt data in
a non-PanelView device. Verify that the address entered is
correct for your network.
If the PanelView terminal location data and programming terminal
configurations are correct, choose Start Upload. A message will appear,
warning you that the addressing information which locates the PanelView
terminal on the network must be correct. If you are sure of your settings,
choose Continue. The upload will begin.
As the upload begins, the Start Upload menu will display information
about the file in the terminal, and the destination of the file on the
development computer’s disk.