Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL - Manual (Page 314)

The Objects
Chapter 10
10-49
In this example, Numeric Cursor Point objects are used to change an array
of values.
To select which value to change, press the SELECT button on the
PanelView terminal to enable the Numeric Input Cursor Points and to open
the scratchpad at the top of the screen. Use the arrow keys to select the
value to change, then use the Numeric Keypad to enter the data into the
window. Use the Enter key to send the data to the PLC controller.
Example 3 (for Touch Screen terminals)
Figure 10.9
Example 3
20387
ENT
9
6
8 7
DEL
5 4
3 2 1
Ċ 0 CLR
J
NNN.N
J
NNN.N
J
NNN.N
J
NNN.N
Keypad Enable Button
DI11/0-17 - Keypad Control Address
DI10/1 - Enter Key Control Address
Numeric Data Display
DO10/0-17
Interlocked
Pushbutton
DI10/0
In this example, all numeric values are entered using one numeric keypad.
Numeric Data displays are used to display the values in the PLC controller
(assigned output addresses). Interlocked Push Buttons are placed next to
each Numeric Data Display to provide a means of selecting which value is
to change.