Rockwell Automation 2755 Enhanced Decoder Series B - Manual (Page 247)

15–59 ASCII Host Commands
Publication 2755-833
IX - Configure AUX Terminal Source Identifier
Command Format: I Xlstring
Function: Defines a source identifier for the AUX port
terminal. Source identifiers are included in
messages sent to the host. They identify whether
the data was scanned (by Scanner A or B) or
entered at the AUX terminal.
Note: This command only applies when the
AUX port is set for manual data entry
operations.
Parameters: lstring
Command
Parameter
Parameter Function Valid Values
l Length of source identifier 0 to 4 ①
String Characters in source identifier Up to 4 characters
① A zero length string will disable the source identifier.
Response: = rr <end>
rr = response code
<end> = end of message control code
Example:
Command: I X3AUX
Parameters: AUX
Command
Parameter
Parameter Function Values
l Length of source identifier 3
String Characters in source identifier AUX
Response: = 00LF
00= command complete
response code
LF= end of message control code
for Line Feed