Rockwell Automation 2755 Enhanced Decoder Series B - Manual (Page 73)

5–12 Introduction to AUX Terminal Configuration
Publication 2755-833
Press [N] or [Esc] to cancel the operation and return
to the Select Operation menu. Press [Y] to recall
the values from storage memory. The recalled
configuration will then control decoder operations.
SAVE Saves the configuration currently in operating
memory to storage memory. The Save command
does not alter the current operation of the decoder.
The following message prompts you to confirm the
save operation.
Press [N] or [Esc] to cancel the operation and return
to the Select Operation menu. Press [Y] to save the
configuration to storage memory.
DEFAULT Copies the factory default configuration parameters
into operating memory. All parameters take effect
immediately, with the following exceptions:
D Host communications parameters: baud rate,
bits/character, parity, host protocol, device
address, ACK character, and NAK character.
These parameters will take effect only after a
Restart.
When you select Default, the following confirmation
message will appear:
Press [N] or [Esc] to cancel the operation and return
to the Select Operation menu. Press [Y] to restore
the factory defaults in storage memory to operating
memory. This operation has no effect on any
configuration parameters previously saved to storage
memory with the Save command. The factory
defaults are listed in Appendix B.
!
ATTENTION: It is good practice to save your
configuration once the required host communications
parameters have been set. Doing so assures you will
retain those parameter settings even after lengthy
periods without power.