Rockwell Automation 2755 Enhanced Decoder Series B - Manual (Page 48)

4–9 Installing the Decoder
Publication 2755-833
Press “1” to proceed to the Symbology configuration screen. A
Caution screen will appear. This screen allows you to disable the
decoder’s optional output modules during configuration. It will
appear each time you select a configuration screen from the Select
Operations menu while the outputs are enabled. More information
on this subject appears in Chapter 5. For now, press any key except
ESC to continue configuration.
Note: Restarting the decoder by selecting “E” from the Select
Operations menu after configuration will reactivate the output
modules.
At the Symbology configuration screen, we suggest resetting the
decoder to assure that you are starting from a default configuration.
To do so:
1. Press ESC to activate the command line at the bottom of the
screen.
2. Use the arrow keys to move the highlight to the “DEFAULT’
option.
3. Press ENTER (or RETURN on some keyboards).
4. Confirm your intention to reset the decoder to its default
configuration by answering yes to the confirmation prompt (press
“Y” in English).
Set Symbology Parameters
Enable the symbology (or symbologies) you would like to read by
using the arrow keys to move the highlight to the appropriate
position. Toggle through the available selections by pressing the
space bar. Press
ENTER to accept each change.