Rockwell Automation FlexPak 3000 Power Module Version 4.2 - Manual (Page 109)

APPENDIX B
49’1340 e FlexPak 3000 B-5
ANLG OUT 1 GAIN ADJ (P.420)
Only available if the I/O Expansion kit is installed. Adjusts analog output 1 (terminals 54 and 55 on the
I/O Expansion board) to allow it to produce a signal from 5.0 to approximately 13.0 VDC. The full scale
value (FSV) is determined by the setting of ANLG OUT 1 SELECT.
Parameter Range: 0.500 to 1.300
Default Setting: 1.000
Parameter Type: Tuneable
OIM Menu Path(s): Input/Output - Analog I/O
Refer also to Parameters: ANLG OUT 1 SELECT (P.418), ANLG OUT 1 SIG TYPE (P.419)
This is typically used to adjust the 10 V full scale output to match the input voltage requirement of
attached equipment. For example, this parameter would be set to 0.800 to match the requirements of
equipment that accepts a 0 to 8 VDC signal. The outputs are only rated to 10 VDC, so gain adjust
values greater than 1.000 might cause the analog output circuit to saturate.
ANLG OUT 1 SELECT (P.418)
Only available if the I/O Expansion Kit is installed.
Selects the signal used to drive analog output 1 (terminals 54 and 55 on the I/O Expansion board).
When the analog output is at its maximum value, the selected signal is at its full scale value.
Parameter Range: See table below for parameter options.
Default Setting: ZERO
Parameter Type: Configurable
OIM Menu Path(s): Input/Output - Analog I/O
Refer also to Parameters: MAXIMUM CURRENT (P.007) MOTOR HOT FLD AMPS (P.510)
MOTOR RATED ARM AMPS (P.008)
MOTOR RATED ARM VOLTS (P.009)
TOP SPEED (P.011)
Signal Selected Full Scale Value
CML FEEDBACK (P.397)
CML REFERENCE (P.396)
CML ERROR (P.398)
SPD LOOP OUTPUT (P.299) ± MOTOR RATED ARM AMPS * MAXIMUM CURRENT
100
SPD LOOP FEEDBACK (P.296)
SPD LOOP REFERENCE (P.295)
SPD LOOP ERROR (P.297)
SPEED RAMP OUTPUT (P.199)
SPEED RAMP INPUT TP (P.198)
SPD SOURCE SELECT OUT (P.193)
TRIM OUTPUT (P.197)
ANALOG TACH FEEDBACK (P.291)
PULSE TACH FEEDBACK (P.292)
OCL OUTPUT (P.848) ± TOP SPEED
ARMATURE VOLTAGE (P.289) ± MOTOR RATED ARM VOLTS
POWER OUTPUT ± MOTOR RATED ARM VOLTS * MOTOR RATED ARM AMPS * MAXIMUM CURRENT
100
FIELD REFERENCE (P.590)
FIELD FEEDBACK (P.589) MOTOR HOT FLD AMPS
OCL REFERENCE (P.845) ± 4095
OCL RAMP OUTPUT (P.846)
OCL FEEDBACK (P.847)
NETW IN REG 1 (P.905)
NETW IN REG 2 (P.906)
NETW IN REG 3 (P.907)
FULL SCALE
ZERO
0