Rockwell Automation FlexPak 3000 Power Module Version 4.2 - Manual (Page 200)

APPENDIX F
F-8 FlexPak 3000 49'1340 e
FlexPak 3000 Main Menu
~
Drive Information
Correct Scaling Jumper Positions
J11 ANLG TACH VLT SCL (P.792)
J14 ANLG TACH VLT RNG (P.793)
J18 ARM I FB RESISTOR (P.395)
PULSE TACHOMETER KIT (P.798)
NETWORK KIT (P.796)
I/O EXPANSION KIT (P.797)
FLD CURRENT REGULATOR (P.586)
POWER UNIT TYPE (P.795)
J15 REGULATOR TYPE (P.799)
J20 FIELD LOSS DETECT (P.597)
J21 FLD SUPPLY JUMPER (P.598)
REGULATOR SW VERSION (P.794)
Operator Interface
PASSWORD
Memory Operations
Memory Save
Memory Restore
Restore Defaults
Reset Clock
Define User Units
Define Speed Units
Define Load Units
Define Outer Control Loop Units
Additional Parameters
P.311 (CML REF LIMIT SELECT)
P.312 (INV FAULT AVOID SEL SEL)
P.226 (NEG CUR LIM INV EN)
P.017 (JOG SPEED 2)
P.122 (STOP DECEL SELECT)
P.608 (TACH LOSS SCR ANGLE)
P.018 (RAMP STOP DECEL TIME)
P.914 (NETW REGISTER MAP SEL)
P.813 (OCL PROP TRIM SELECT)
P.521 (FIELD REF SELECT)
P.490 (DIG IN 0)
P.428 (DIG IN 0 SELECT)
P.227 (TACH LEAD FLT THRESH)
P.228 (TACH LEAD FLT DELAY)
P.609 (PHASE LOSS DETECT EN
) not available in SW-V4.1
P.814 (OCL TYPE3 POSN REG EN) not available in SW-V4.1
P.915 (CNI PROG/RUN MODE) not available in SW-V4.1