Rockwell Automation FlexPak 3000 Power Module Version 4.2 - Manual (Page 56)

DRIVE SETUP AND ADJUSTMENT
FlexPak 3000 49’1340 e 4-14
4.14.4 Reset Clock
This feature of the Operator Interface menu resets the elapsed time clock.
FlexPak 3000 Main Menu

 Operator Interface*
The elapsed time clock indicates the number of days, hours, minutes and seconds since the
last powerup. This clock is only visible if a fault or an alarm exist when reviewing the fault and
alarm logs. Pressing ENTER while the choice is at Reset Clock will reset the readouts of the
elapsed time clock to "00" and display the following message:
Reset Clock
DRIVE CLOCK HAS BEEN RESET.
Press CANCEL to continue.
$$
$$
Fault
Alarm
Interlock OK
Drive Ready
Running
Current Limit
Torque Limit
PROGRAM KEYPAD MANUAL FORWARD
4.14.5 Define User Units
1. Select "Define User Units" from the "Operator Interface" menu.
FlexPak 3000 Main Menu

 Operator Interface*
2. Move the cursor to "Define User Units" and then press ENTER. The following menu is now
displayed:
Define User Units
➤ Define Speed Units
Define Load Units
$$
$$
Fault
Alarm
Interlock OK
Drive Ready
Running
Current Limit
Torque Limit
PROGRAM KEYPAD MANUAL FORWARD
4.14.5.1 Define Speed Units
1. Move the cursor to Define Speed Units or Define Outer Control Loop Units, press ENTER. If
you select speed units, the following modification screen appears:
Define Speed Units
SPEED UNITS SELECT RPM
➤ RPM
%
OTHER
$$
$$
Fault
Alarm
Interlock OK
Drive Ready
Running
Current Limit
Torque Limit
PROGRAM KEYPAD MANUAL FORWARD
The OCR loop units screen looks the same, except that AMPS is an option instead of RPM.
2. Select the unit of your choice (RPM, AMPS, or %) or use OTHER to customize a label for
speed units. See Step 3. if OTHER is selected.