Rockwell Automation FlexPak 3000 Power Module Version 4.2 - Manual (Page 16)

INTRODUCTION TO THE DRIVE
FlexPak 3000 49’1340 e 2-8
Rockwell Automation offers modification kits that broaden the application range of the drive.
A summary of these kits is presented in the following Table 2-4.
Related Instruction Manuals are listed in Table 1-1, Section 1.4.
Table 2-4 - Drive Modification Kits
Name Description Part
Number
Pulse Tacho
Feedback Kit PTK Allows for digital pulse tachometer speed feedback on high
performance regulation applications. (Kit includes cable). 762.70.00
Enhanced Field
Supply kit FVR Provides electronic field voltage trim and field economy. It replaces
the standard field supply. 762.70.10
Field Current
Regulator kit
FCU4
FCU10
FCU15 Provides field economy, as well as pre-weakening of the field
using a fixed reference or field weakening for above base speed
operation. Tachometer feedback is required with this kit.
This kit replaces the standard field supply. 762.70.50
762.70.60
762.70.70
(4,10,15A)
I/O Expansion
Board IOE Mounts on the FlexPak 3000 chassis and gives the FlexPak 3000
additional analog, frequency, and digital I/O capability. 762.70.80
AutoMax Network
Communic. kit
AMXF Allows the FlexPak 3000 to communicate on the Reliance AutoMax
Distributed Control System (DCS). (Kit contains board & cable). 762.70.40
Interbus Communi-
cation kit IBSF Allows the FlexPak 3000 to communicate over the standardized
field bus system INTERBUS. (Kit contains board & cable). 762.70.45
Profibus Communi-
cation kit PDPF Allows the FlexPak 3000 to communicate over the standardized
Profibus-DP system. (Kit contains board & cable) 762.70.95
ControlNet
Communication
Board CONF Allows a FlexPak to communicate over the open protocol
ControlNet network. Mounts inside the FlexPak and includes
terminals for network connections. The AMX Network Comm.
board cannot be used when using the ControlNet. 762.70.96
DeviceNet
Communication
Board DNC Allows a FlexPak to communicate over the open protocol
DeviceNet network. Mounts inside the FlexPak and includes
terminals for network connections. The AMX Network Comm.
board cannot be used when using the DeviceNet board. 762.70.90
Drive Control
Configuration
Software
CS3000-V6 Windows-based software that allows the user to connect any
personal computer running Micro-soft Windows version 3.1 or later
to a FlexPak 3000 drive. Allows you to create, store, upload, and
download drive configurations. You can also monitor and change
parameters through the PC and read and reset the drive’s fault
log. 788.05.30
Interface Cable for connecting the drive to PC (25-pin to 9-pin) 772.27.00
Keypad Drive
Configuration
Module KDCM Operator Interface that allows you to access and change drive
parameters, read and clear the drive’s alarm and fault log.
The DCM cannot control the drive. 922.95.10
Keypad Operator
Interface Module
KOIM
(M/N 317C160D)
Allows you to control (e.g. Start, Stop, Jog) the drive.
You can also monitor and change parameters, read and clear the
drive's alarm and fault log. 922.95.00
OIM Remote
Mounting kit DMK
(M/N 905FK0101)
Provides for remote mounting of the OIM up to 5 meters away
from the drive. Contains also the cover plate (762.70.31) for the
regulator unit. 762.70.30