Rockwell Automation FlexPak 3000 Power Module Version 4.2 - Manual (Page 17)

INTRODUCTION TO THE DRIVE
49’1340 e FlexPak 3000 2-9
2.5 Controls/Indicators
See Figure 2-2 for location of the controls and indicators for the Keypad OIM.
Drive fault and status indicators are listed in Table 2-5.
LCD Display LCD-Indicators
Control Key
LCD-Indicators
OIM Programming
Keys
Fault
Alarm
Interlock OK
Drive Ready
Running
Current Limit
Torque Limit
PROGRAM
MONITOR
STOP
FAULT JOG FORWARD
REVERSE
CONTROL
SOURCE
SELECT AUTO
MANUAL
PROGRAM KEYPAD MANUAL FORWARD
RESET
+
RUN
HELP
?
CANCEL ENTER
Drive Control
Keys
Figure 2-2: Operator Interface Module OIM
2.5.1 Indicators
LCD (Liquid Crystal Display) and LED (Light Emitted Diode) displays are used to indicate the
status of the drive. LCD indicators are located on the OIM to the left of the text for the indicator.
LED indicators are located on the regulator board which is located behind the OIM.
LCD Indicators
An LCD indicator is on when a field is present !! ; off when extinguished. In Figure 2-2, the
Interlocks OK and the Drive Ready indicators are on. Table 2-5 contains a list of drive and fault
status indicators with their associated description.