Rockwell Automation FlexPak 3000 Power Module Version 4.2 - Manual (Page 189)

APPENDIX E
49’1340 e FlexPak 3000 E-5
Table E.1 - Fault Codes (Continued)
CODE DISPLAY DESCRIPTION
F00063 SELF TUNING
FAULT Maximum current with minimum rotation.
Possible causes:
• Motor can not rotate freely due to mechanical friction.
• Motor load is too high.
• Motor field not at normal operating temperature.
F00064 SELF TUNING
FAULT Attached inertia is out of range.
Possible causes:
• Maximum self tune speed reached.
• Overhauling load present.
• High mechanical friction present.
• The Speed Loop can not be self tuned. Tune Speed Loop manually.
F00065 SELF TUNING
FAULT Speed unstable.
Possible causes:
• CML not properly tuned before Speed Loop.
• Tachometer feedback connected incorrectly.
F00066 SELF TUNING
FAULT SELF TUNE STABILITY (P.219) is too low.
Possible cause:
• Specified stability is less than that calculated by CML self tuning,
use 50 or greater.
F00067 SELF TUNING
FAULT SELF TUNE STABILITY (P.219) is too low.
Possible cause:
• Specified stability is less than that calculated by CML self tuning,
use 75 or greater.
F00089
to
F00099 SELF TUNING
FAULT Fatal self tuning fault occurred.
Possible cause:
• Self tuning was unable to complete; tune manually.
F00100
1)
MAIN CONTACTOR
DID NOT OPEN The main contactor was not open when a run or jog request is applied.
Possible causes:
• Disconnected, loosely connected, or damaged main contactor (K1M)
or Aux. contactor (K1) wiring.
• Main contactor or Aux. Main contactor failure.
• Disconnected, loosely connected, or damaged main contactor
control wiring (MCR).
F00200 POWER FAILURE The power supply input voltage momentarily went below tolerance.
Possible causes:
• AC line voltage dip.
• Disconnected, loosely connected, or damaged J7 ribbon cable or
power supply input wiring
1) When after stop command, the auxiliary contactor does not indicate that the main contactor opened,
this fault indication is time delayed: 1000 msec fixed on SW-V4.2 (400 msec on SW-V4.1)