Rockwell Automation FlexPak 3000 Power Module Version 4.2 - Manual (Page 190)

APPENDIX E
FlexPak 3000 49’1340 e E-6
Table E.1 - Fault Codes (Continued)
CODE DISPLAY DESCRIPTION
F00700 FACTORY
DEFAULTS
RESTORED The parameter values stored in retentive memory were determined to
be invalid, factory default values have been restored. All parameter
values (including any factory set parameters) must be re-adjusted
based on your particular application's requirements before the drive is
operated. After all parameters have been set properly, a memory save
must be performed.
Possible causes:
• Power loss during a prior memory save.
• New or defective regulator board.
F00701 FAULT LOG
RESTORE FAILURE The fault log information stored in retentive memory was determined to
be invalid, the fault log has been cleared.
Possible causes:
• Power loss during a prior fault log save.
• Defective regulator board.
F00702 KEYPAD REF
RESTORE
FAILURE
The keypad reference value stored in retentive memory was
determined to be invalid, the keypad reference has been set to the
MINIMUM SPEED value.
Possible causes:
• Power loss during a prior keypad reference save.
• Defective regulator board.
F00703 OIM KEY
RESTORE
FAILURE
The OIM key states stored in retentive memory were determined to be
invalid, the
FORWARD/REVERSE key has been set to FORWARD , the
AUTO/MANUAL key has been set to MANUAL .
Possible cause: Defective regulator board.
F00800 INVALID FIELD
INSTALLED Installed field supply is not supported by the regulator.
Possible causes:
• Disconnected, loosely connected, or damaged field supply wiring.
• Regulated field supply failure.
• Defective regulator board.
F00801 FIELD FEEDBACK
OFFSET TOO HIGH Regulated field supply feedback offset is too high.
Possible causes:
• Disconnected, loosely connected, or damaged field supply wiring.
• Regulated field supply failure.
• Defective regulator board.
F01000
to
F01999 MICROBUS
FAULT An error occurred on the Microbus.
Possible causes:
• Electrical noise due to improper wiring practices or unsuppressed
brake coils, relays, or contactors.
• Disconnected, loosely connected or damaged Microbus ribbon cable.
• Defective regulator board.
• F01000-F01799: Defective Microbus peripheral or defective
Regulator board.
• F01810-F01816: A Microbus peripheral was found that is not
supported by the regulator software.
F00999
and
F02000
to
F03999 MICRO-
PROCESSOR
HW/SW FAULT A microprocessor hardware or software fault occurred.
Possible causes:
• Electrical noise due to improper wiring practices or unsuppressed
brake coils, relays, contactors.
• Defective regulator board.