BUCHI DuMaster D-480 - Manual (Page 150)

Operation Manual D-480 ©BÜCH Labortechnik AG
7 - Using the instrument 150
Saving the sample view
Saving the sample view
Proceed as follows:
 Open the "View configuration" dialog by selecting View > Gridview > Save configuration.
 Enter the name of the view in the text box at the top and click Save. The view is saved and can
be loaded at a later point.
Loading a sample view
Loading a sample view
Proceed as follows:
 Open the "View configuration" dialog by selecting View > Gridview > Load configuration.
 Select the desired view in the listbox and click Load. The desired view is loaded.
Configure statistics view
Configure statistics view
Proceed as follows:
 If the statistics view of the combi view is not already being displayed, execute the command View
> Toggle until statistics view appears or click on Statistic field in the menu bar above the combi
view.
 Klick on the statistic view to highlight it.
 Specify what you want to have displayed in the view. Open the "Configure Statistic Pane" dialog
by selecting View > Statistic > Configure.
 Decide:
If you want to...
 ... show a value: Check the appropriate checkbox.
 ... hide a value: Uncheck the appropriate checkbox.
 Click OK. This closes the dialog and saves your settings.
Generating statistical data
What are statistical data?
Statistical data are mean values and standard deviations computed from groups of measuring data.
The operator compiles the groups, that may consist of analyzed samples and samples not yet
measured.
Ways of generating statistical data
There are two ways of generating statistical data:
 You can generate statistical data fully automated. In this case, the software combines all samples
of the same name into groups. The user can only exclude specific samples from the calculation.
Statistical data are then automatically generated for these groups.