BUCHI DuMaster D-480 - Manual (Page 328)

Operation Manual D-480 ©BÜCH Labortechnik AG
10 - Menu and dialog descriptions 328
The dialog
The appearance of the dialog depends on the selected peak type.
Open
Open the dialog by selecting Math. > Manual Peak Integration > Integrate.
Elements
The following describes the elements of the dialog.
Label Element type Meaning
and/or
Button Allows the setting of the start tag of the single and/or total
peak.
and/or
Button Allows the setting of the end tag of the single and/or total
peak.
Button Allows the vertical movement of the baseline. This button is
only accessible if the option "straight baseline" is activated.
Button Allows the setting of the start tag of the superimposed
peak.
Button Allows the setting of the end tag of the superimposed peak.
Button Allows the setting of an intermediate point for a better
adjustment to the socket course.
Assignment Button Allows the assignment of the manually integrated peak
areas to one element component.
Close Button Closes the dialog.
Clicking a symbol button results in an activation of the corresponding function. Reclicking the same
symbol button deactivates the function. Clicking a different symbol button results in its acitvation as
well as in the deacitivation of the previously activated function. Which function is currently activated
can be seen from the green bar above the corresponding symbol button.
Further information
Further information includes instructions in which the dialog is used and knowledge articles
concerning the dialog:
 Manual peak integration (on page 152).
Area assignment (Dialog)
Function
In the dialog it is defined to which element the manually integrated peak area(s) shall be assigned.
The dialog
The appearance of the dialog depends on the selected peak type.
Open
Open the "Define peak start/end" dialog via Math. > Manual Peak Integration > Integrate. Then,
after you have performed the manual integration, open the "Area assignment" dialog by clicking the
Assign button.