BUCHI DuMaster D-480 - Manual (Page 28)

Operation Manual D-480 ©BÜCH Labortechnik AG
2 - Basic security settings 28
Overheating of tube fillings
Please observe the following instruction:
Caution Overheating if tube fillings are not appropriate for the operating mode!
Overheated tube fillings melt, run into the furnace area and destroy the furnace.
Make sure that the tube fillings correspond to the selected operating mode.
Working with the database
Please observe the following instructions:
Caution Data loss
After reorganizing the database via Clean all sample data and the contents of the
logbook are irrevocably deleted.
Always backup your data before reorganizing the database via Clean.
Caution Data loss
Restoring the database via Restore irrevocably overwrites all sample data, the
contents of the logbook and the database configfuration parameters.
Always backup your data before restoring the database via Restore.
Improper changes
Please observe the following instruction:
Caution Improper changes impair proper operation of the system and may destroy system
components.
Only configure the instrument if you are authorized to do so and observe the
operating instructions.
Baking out combustion tube and reduction tube
Please observe the following instructions:
Warning Gas pressure and caustic substances in the instrument
Consumables may escape under pressure and cause chemical burns. Before
performing the work:
Shut off the gas supply. To do so, execute the Options > Maintenance >
Replace parts command.
Warning Hot components in the instrument
When working inside the instrument there is a risk of burning as many parts of the
instrument are hot.
When working inside the instrument always wear protective glasses and the
enclosed heat protection gloves.
Mixing up gas inlets
Please observe the following instruction:
Caution A mix-up of the gas inlets may lead to destruction of the instrument.
Connect the supply lines carefully and observe the diagram.