BUCHI DuMaster D-480 - Manual (Page 76)

Operation Manual D-480 ©BÜCH Labortechnik AG
5 - Work performed by the system administrator 76
Installing and updating the software
Conditions for installation
In order to install the software correctly, administrator rights for the PC must be available.
Requirements for operation
Do the following to be able to operate the software without any problems:

On the PC where the software is installed, check power management settings under Control
Panel > Power Management or under Control Panel > Power Options. The following options
must be set to "Never":
 "Turn off monitor"
 "Turn off hard disks"
 "System stand by"
 "System hibernates"
 Power management must also be disabled in the PC's BIOS.
The PC on which the software is installed must not be overloaded with other software. This could
cause unstable operation of the software.
Installing and updating the software
Proceed as follows:
 Insert the enclosed CD in the CD-ROM drive. The CD usually starts automatically.
 If the CD does not start automatically, start it by running setup.exe on the CD.
 Select the desired language.
 The installation wizard is displayed. Click Next and follow the steps of the installation wizard.