BUCHI DuMaster D-480 - Manual (Page 86)

Operation Manual D-480 ©BÜCH Labortechnik AG
5 - Work performed by the system administrator 86
Defining the analyzer / PC interface
Note
The operating software can only be operated in combination with the analyzer if the serial number of
the instrument matches the software licence number. This ensures that the analyzer is always
operated together with the same software and the settings recorded in the logbook.
Safety instruction
Strictly observe the safety instruction "Improper changes" under Warning notes during operation
(on page 24).
Defining the analyzer / PC interface
Proceed as follows:
 Open the "Device configuration" dialog by selecting Options > Configuration.
 Select the "DEVICE.INI" tab. Then select the "Analyzer Port" section by clicking the arrow next to
the "Section" dropdown listbox.
 Select in the "Items" listbox the entry "Name" and click Edit. The "Configure key value" dialog is
displayed:
 Enter the name of the serial port (e.g. "COM2") in the "Value" field and click OK. The "Comment
modification" dialog is displayed.
 Enter a justification in the "Comment modification" dialog and click Close.
 Click OK in the "Device configuration" dialog. Your settings are saved and the dialog is closed. A
message window appears which informs that the modification will only become operative after
the instrument software has been left and re-started.
 Click OK and quit the operating software.
 Restart the operating software as required.
Dialog details
Details on the "Device configuration" dialog can be found in Device configuration (on page 320).
Defining the LIMS / PC interface
Defining the LIMS / PC interface
Proceed as follows:
 Open the "LIMS settings" dialog by selecting Options> Settings> LIMS.
 Select the "Communication" tab. Define your settings.
 Click OK in the "LIMS settings" dialog. Your settings are saved and the dialog is closed.
Dialog details
Details on the "LIMS settings" dialog can be found in LIMS settings (on page 311).