BUCHI DuMaster D-480 - Manual (Page 278)

Operation Manual D-480 ©BÜCH Labortechnik AG
10 - Menu and dialog descriptions 278
If 21 CFR Part 11 functionality is enabled, a new version of the document is created the next time it is
saved.
Set stop tag (Dialog)
Function
In this dialog you can specify the sample at which to set the stop marker. Usually, the program
automatically moves the stop marker while you input sample data. Therefore it is only necessary to
move the stop marker manually in special cases.
Open
Open the dialog:
 via the menu command Edit > Stop tag or
 by clicking the right mouse key to the corresponding sample cell. Select Set stop tag... from the
popping-up context menu.
Elements
The following describes the elements of the dialog.
Label Element type Meaning
Stop marker at: Textbox with
buttons Field to input the sample number at which to set the stop
marker.
You can also set the sample number in the textbox using
the arrows.
OK Button Saves the setting.
Cancel Button Aborts the process.
Further information
Further information includes instructions in which the dialog is used and knowledge articles
concerning the dialog:
 Stopping continuous analysis (on page 250).
 Right mouse button function (on page 69).
Select current sample (Dialog)
Function
You set the number of the current sample in the dialog. The current sample is the sample that is
currently being analyzed (analysis mode) or that will be analyzed next (idle mode). It is only
necessary to set the current sample after breakdowns (power failure, etc.), for example if the carousel
position no longer matches the serial sample number.
Note
The current sample is only set in sample memory. Therefore, it is necessary to check that the data of
the current sample in sample memory match the data of the sample on the carousel that will actually
be analyzed next. Otherwise, measurements will be incorrect.
Open
Open the dialog:
 via the menu command Edit > Current sample or