BUCHI DuMaster D-480 - Manual (Page 286)

Operation Manual D-480 ©BÜCH Labortechnik AG
10 - Menu and dialog descriptions 286
View > Gridview > Auto align (Command)
What is the command used for?
This command optimizes the sample view:
 The individual columns are automatically widened or narrowed to make the headers and entries
completely visible.
Configure graph view (Dialog)
Function
In this dialog you can define the appearance of the graph view.
Open
Open the dialog via View > Graphic > Configure. Progression view (graph view) must be enabled in
order to open the dialog.
Elements
The following describes the elements of the dialog.
In section "Y axis configuration":
Label Element type Meaning
{Graph type} Checkbox Displays the appropriate progression graph. You can set
the scale range of the progression graph in the adjacent
textbox.
Note: The number of progression graphs you can display at the same time is limited to four for the
sake of clarity.
In section "Zero line":
Label Element type Meaning
At height Textbox with buttons In this field you specify which of the horizontal grid lines in
the graph view is assumed to be the zero line. A value of 0
means that the zero line is at the bottom edge of the graph
view.
In section "X axis configuration":
Label Element type Meaning
Time axis Textbox In this field you can define the division of the time axis (X
axis).
Remaining elements:
Label Element type Meaning
During analysis
run display current
sample only Checkbox During an ongoing analysis you cannot view a progression
graph of a previously analyzed sample.
OK Button Saves new settings
Cancel Button Discards settings not yet saved.