BUCHI DuMaster D-480 - Manual (Page 157)

Operation Manual D-480 ©BÜCH Labortechnik AG
7 - Using the instrument 157
Setting the size of the graph with the mouse
Proceed as follows:
 Drag a rectangle in graph view using the mouse.
 The selected area is displayed larger.
Setting the zoom factor back to 1
By clicking the button at the upper left corner of the graphic filed you can set the zoom factor from
any value back to 1.
Configure report
Configure report
Proceed as follows:
 Open the "Configure Report" dialog by selecting File > Report configuration.
 Define the print settings as required:
 Enter up to three headers in the "Title" section.
 Check the appropriate options in the "Report options" section.
 Click OK. This closes the dialog and saves the settings.
Display print preview
Display print preview
Proceed as follows:
 Open the "Configure report" dialog in the operating software by selecting File > Print preview.
 Define your report settings. See Configure report (on page 157). You can also change the
report type in this dialog below the icon. Then click OK. Print preview is displayed.
 Assess the print preview:
 The Next and Previous buttons allow you to browse multiple page documents.
 The Two Pages and One Page buttons allow you to view two pages next to each other or a
single page.
 The Zoom in and Zoom out buttons allow you to zoom the document in/out in order to see
it better.
 Decide:
If the print preview...
 ... is OK and you want to print out the document: Click Print. The "Configure report" dialog
is displayed again, click OK. The "Print" dialog is displayed.
 ... is not OK and you want to change it: Click Close. Open the "Configure Report" dialog by
selecting File > Report configuration. See Configure report (on page 157).