BUCHI DuMaster D-480 - Manual (Page 321)

Operation Manual D-480 ©BÜCH Labortechnik AG
10 - Menu and dialog descriptions 321
Safety instruction
Strictly observe the safety instruction "Improper changes" under Warning notes during operation
(on page 24).
Note
This section only describes the sections of the tabs in which you can make changes via the "Device
configuration" dialog only, as these sections do not have their own settings menu.
If 21 CFR Part 11 functionality is enabled, every change to the configuration must be justified in the
"Comment modification" dialog.
Open
Open the dialog by selecting Options > Configuration.
Elements
The following describes the elements of the dialog.
Valid for all tabs:
Label Element type Meaning
Section Dropdown listbox This field lists the available sections. Field to input a name for
a new section.
Entries Listbox This field lists the entries of a previously selected section.
New Section Button Creates a new section under the name previously entered in
the dropdown listbox.
Edit Button Opens the "Configure key value" dialog. Allows you to edit a
section entry previously selected from the list.
Delete Button Deletes a section previously selected in the dropdown listbox.
Deletes a section entry previously selected in the listbox.
Paste Button Opens the "Configure key value" dialog. Allows you to insert
new entries in a section.
Import Button Opens the "Open" dialog. Allows you to import further
sections.
Export Button Opens the "File save as" dialog. Allows you to export
sections.
Delete all Button Deletes all entries which are included in the activated tab.
OK Button Saves new settings
"DEVICE.INI" tab
The following table describes the entries under the "AnalyzerPort" section:
Entry Standard Description
Name COM1 Defines the serial interface between the PC and the analyzer.
Baud 9600 Defines the transfer rate of the serial interface between the PC
and the analyzer.
Data 8 Defines the number of databits of the serial interface between the
PC and the analyzer.
Stop 1 Defines the number of stopbits of the serial interface between the
PC and the analyzer.