Configuring the maintenance protocol – Verilink Net Engine (3150-30626-001) Product Manual User Manual
Page 118
NetEngine IAD User Guide
WAN Configuration
99
Figure 4–63. FRF.12 Configuration Menu for CopperMountain
Type the option and proceed to the corresponding section.
Enabling or Disabling Coppermountain Fragmentation
1. Type
1
to enable or disable CopperMountain fragmentation.
The IAD displays the status and a prompt:
CuMtn Fragmentation is currently DISABLED
Enter E to Enable, D to Disable:
Type
E
to enable CopperMountain fragmentation. Type
D
to disable it.
2. The IAD saves the configuration and displays the FR FRF.12
Configuration menu. Press Escape to continue.
3. Reset the IAD (page
) when you finish Frame Relay configuration.
Setting Real Time DLCI
1. Type
2
to set up the IAD for real time DLCI.
2. The IAD displays the port list and prompt:
Port DLCI Encapsulation
---- ----- -------------
1 16 RAW (No Encapsulation)
Select Port: [1-8]
Type the port number corresponding to the DLCI you want to set to
real-time.
3. The IAD saves the configuration and displays the FR FRF.12
Configuration menu. Press Escape to continue.
4. Reset the IAD (page
) when you finish Frame Relay configuration.
Configuring the Maintenance Protocol
To configure the maintenance protocol:
1. On the Main menu, select Configure WAN to display the WAN
Configuration menu.
2. Select Configure FR Options to display the Frame Relay Options menu
3. Select Configure Maintenance Protocol to display the Frame Relay
Maintenance Protocol menu.
*****************************************
FR FRF.12 Configuration
*****************************************
1. Enable/Disable CuMtn Fragmentation
2. Set Real-Time DLCI