Verilink Net Engine (3150-30626-001) Product Manual - Manual (Page 54)

NetEngine IAD User Guide
Administration 35
Setting up
Your LAN
Connection
The IAD LAN port may be set for full duplex Ethernet operation if your IAD
is set up as a router. Full duplex mode allows simultaneous transmission
and receipt of Ethernet packets.
On the Main menu, type 6 (Configure LAN) to display the LAN
Configuration menu.
Figure 3–5. LAN Configuration Menu
Selecting the Connection
If more than one connection is defined, the IAD prompts you to specify the
port number. Type the number of the port, select enable or disable and
press Enter.
Establishing LAN Speed and Duplex Mode
1. Type the option number of the speed and duplex mode.
2. The IAD saves the configuration. Press Escape to return to the Main
menu.
3. Reset the IAD (page 15 ) for changes to take effect.
You can display the current LAN settings using the Display Current
Configuration command in the Reports menu (page
203 ).
*******************************************
LAN Configuration Menu
*******************************************
1. 10 Mbps Full Duplex
2. 10 Mbps Half Duplex
3. 100 Mbps Full Duplex
4. 100 Mbps Half Duplex
5. Auto Negotiate the Speed, Full Duplex
6. Auto Negotiate the Speed, Half Duplex
7. Auto Negotiate Speed & Full/Half Duplex Mode
8. Display MII & FEC Registers
NOTE Full duplex Ethernet operation is controlled by the switch. If
the switch is set to full duplex, you may enable it in the IAD. If
you enable full duplex Ethernet in the IAD when the switch is
operating in normal half duplex mode, your IAD will not
communicate on the LAN.