Verilink Net Engine (3150-30626-001) Product Manual - Manual (Page 169)

NetEngine IAD User Guide
Voice Path Configuration 150
Setting
Country
Mode
The country mode selection menu allows you to select a national
parameter list file for specified countries or regions. Each file contains
definitions of call progress tones, normal and distinctive ring cadences,
ringer frequency, hook flash timings, and SLIC settings.
To set a specific country mode, type C to display the Country Mode
Selection menu, which contains commands to set the base country.
Specifications for each country code includes minimum and maximum
flash hook, ring frequency, receive and transmit gain, reference or input
impedance, and load impedance settings. These specifications are listed
in
Appendix B. , Country Codes, on page 277 .
When you select a specific country mode, the values are set automatically:
Figure 7–11. Country Mode Selection Menu
1. Type the letter corresponding to the country mode you want to set.
2. The IAD saves the mode you’ve selected and displays the menu.
3. Press Escape to return to the Voice Configuration menu and continue
with other voice path configuration.
4. Reset the IAD (page 15 ) when you finish voice path configuration.
NOTE The country mode option is only available on IADs with POTS
ports. This option does not apply to an ISDN-based IAD.
LAN LINK LAN ACT WAN LINK VOICE POWER
6108
6504
6508 Ring frequency and impedance settings are automatically
applied to the 6108, 6504 and 6508.
*******************************************
Country Mode Selection
*******************************************
Current Country Name is ETSI Generic
Current Country Mode is Europe
A. Australia Complex Impedance
B. ETSI Generic
C. United States of America
NOTE To add support for any of the countries/regions listed above
but not displayed in the Country Mode Selection menu,
contact your service provider to obtain the file.