Enabling and disabling stp debug mode, Enabling and disabling dhcp client debug mode, Displaying error dumps – Verilink Net Engine (3150-30626-001) Product Manual User Manual
Page 63
NetEngine IAD User Guide
Administration
44
Enabling and Disabling STP Debug Mode
When you enable STP debugging, the IAD displays STP debug
messages. To enable or disable STP debugging, follow these steps:
1. Type
S
on the Debug menu. The IAD displays the STP debug status:
STP Debug Mode is currently DISABLED
2. Type
E
to enable STP debugging, or type
D
to disable it.
The IAD sets STP debug mode to the setting you entered, and displays
the Debug menu.
Enabling and Disabling DHCP Client Debug Mode
When you enable DHCP Client debugging, the IAD displays DHCP Client
debug messages. To enable or disable DHCP Client debugging, follow
these steps:
1. Type
I
on the Debug menu. The IAD displays the DHCP Client debug
status:
DHCP Client Debug Mode is currently DISABLED
2. Type
E
to enable DHCP Client debugging, or type
D
to disable it.
The IAD sets DHCP Client debug mode to the setting you entered, and
displays the Debug menu.
Displaying Error Dumps
This option displays the most recent error encountered during the active
session. This option is for factory use only.