Verilink Net Engine (3150-30626-001) Product Manual - Manual (Page 203)

NetEngine IAD User Guide
Multicast Configuration 184
Adding a
Multicast
Routing
Source
Type A to add a Multicast Routing Source. The IAD creates a multicast
routing source and adds it to the Multicast Routing Source Table.
1. The IAD displays the IP address prompt:
Enter IP address for the Source:
Type the source IP address and press Enter.
2. The IAD displays the current subnet mask and prompt:
Enter subnet mask for the source:
(255.255.255.0) ->
Type the new subnet address and press Enter.
3. The IAD displays the available interfaces and a prompt:
Available Interfaces:
1. G2237 xDSL
2. 10/100BaseT Ethernet
0. (Abort)
Selection:
Type the option number to select the interface.
4. The IAD displays the port table for this interface and prompts for a port.
Port VPI VCI Encapsulation Type PCR Service
1 0 40 RFC 1483 (with LLC Encap)3641 UBR
Total = 3641 cps
Maximum PCR this interface can support = 3622 cps
Select Port: [1-8]
Type the port to configure and press Enter.
5. The IAD saves the new configuration and displays the Multicast
Configuration menu.
6. Reset the IAD (page 15 ) for changes to take effect.