Configur- ing the g.shdsl interface, Figure 4–10. g2237 xdsl configuration menu, Configuring the g.shdsl interface – Verilink Net Engine (3150-30626-001) Product Manual User Manual
Page 80
NetEngine IAD User Guide
WAN Configuration
61
Configur-
ing the
G.SHDSL
Interface
The tasks described in this section all begin on the G2237 xDSL
Configuration menu. The tasks are described so you can proceed through
them sequentially. You should review and update each of these options as
necessary, and reset the IAD when you finish WAN configuration.
To configure the G.SHDSL interface, type
2
(Configure Physical Interface)
on the WAN Configuration menu to display the G2237 xDSL Configuration
menu:
Figure 4–10. G2237 xDSL Configuration Menu
LAN LINK
LAN ACT
WAN LINK
VOICE
POWER
6504
6504i
6508
This section is only for configuring the G.SHDSL (Annex A or
Annex B) WAN interface, available on the 6504, 6508, and
6504i.
******************************************
G2237 xDSL Configuration
******************************************
Current Interface Type is: G.SHDSL-A.
Mode: CPE, Rate Mode: FIXED,
Line Rate: 88K, Debug: DISABLED.
1. Select xDSL Interface Type
2. Select CPE/CO Mode
3. Enable/Disable Adaptive Rate Mode
4. Select Line Rate
D. Enable/Disable G2237 xDSL Debug Messages