Verilink Net Engine (3150-30626-001) Product Manual User Manual
Page 126
NetEngine IAD User Guide
Router Configuration
107
8. Configuration is complete. The IAD displays the following prompt:
Save new IP Information?
->(Y)
Type
Y
to confirm your changes, or press Escape to cancel.
9. If you confirm, the IAD saves the settings.
10. If bridging is enabled and an IP address is assigned on the WAN
interface, the IAD displays the IP Over Bridge prompt:
Both bridging and IP address are specified for this
interface.
Currently IP over bridge is enabled.
Enter E to Enable, D to Disable:
11. Type
E
to enable IP Over Bridge on the WAN port, or
D
to disable it.
12. The IAD saves the changes and displays the Router Configuration
menu.
13. Repeat these steps for each remaining port to configure.
14. Continue with other configuration tasks, or press Escape to return to
the Main menu.
15. Reset the IAD (page
) when you finish router configuration.