Manual configuration, Figure 7–23. aal2/les manual configuration menu – Verilink Net Engine (3150-30626-001) Product Manual User Manual
Page 181
NetEngine IAD User Guide
Voice Path Configuration
162
settings is a message indicating the IAD will be configured for the
selected gateway after reset.
3. Reset the IAD (page
) when you finish voice path configuration.
Manual Configuration
Type
C
to display the AAL2/LES Manual Configuration menu (current
settings eliminated from this example):
Figure 7–23. AAL2/LES Manual Configuration Menu
Type the option for the command to execute and proceed to the
appropriate section.
Enabling and Disabling Ports
1. Type
P
to enable and disable ports.
2. The IAD displays the port control prompt:
Port Control x(10011001):
Enter a zero (0) in each port location to disable the port; enter a 1 in
each port location to enable the port. Press Enter to complete the step.
3. The IAD displays the AAL2/LES Manual Configuration menu.
4. Reset the IAD (page
) when you finish voice path configuration.
Setting the CAS Refresh Rate
1. Type
R
to set the CAS refresh rate.
2. The IAD displays this prompt:
New CAS refreshing rate in seconds (0 to DISABLE):
Enter a zero (0) to disable CAS refresh, or enable CAS refresh by
entering a non-zero refresh rate value.
3. The IAD displays the AAL2/LES Manual Configuration menu.
4. You must reset the IAD (page
) before enabling Idle CAS refresh.
Enabling and Disabling Idle CAS Refreshing
1. Type
I
to enable or disable idle CAS refreshing. You can only enable
idle CAS refresh when CAS refresh is enabled (immediately
preceding).
2. Type
E
to enable Idle CAS refresh, or
D
to disable Idle CAS refresh.
3. The IAD displays the AAL2/LES Manual Configuration menu, and
indicates in the message section that the change in the Idle CAS
refresh will take place when the IAD is reset.
************************************
AAL2/LES Manual Configuration
************************************
P. Enable/Disable Ports
R. Set CAS refreshing rate
I. Enable/Disable idle CAS refreshing
S. Change Max. CPS-SDU Size; 45/64 Octets
T. Set "Combine Use" Timer
U. Enable/Disable User State Control
D. Enable/Disable Dialed Digit
A. Manual ATM Pace Control