Basic router setup tasks, Figure 5–1. router configuration task flowchart – Verilink Net Engine (3150-30626-001) Product Manual User Manual
Page 123
NetEngine IAD User Guide
Router Configuration
104
Basic
Router
Setup
Tasks
To configure the IAD as a router, you should complete the following tasks:
u
Configure IP addresses on the LAN and WAN ports (page
)
u
Enable RIP poisoned reverse (recommended—page
), add a static
route (page
), or add a default route (page
)
u
Disable bridging globally (page
) or by port (page
)
u
Disable Spanning Tree Protocol (STP) globally (page
) or by port
)
Use this flowchart to plan your tasks, based on your router configuration
requirements.
Figure 5–1. Router Configuration Task Flowchart
Main
Menu
Yes
Yes
Enable
bridging
interface
per port
End
Enable RIP
globally
All interfaces
configured
with IP?
No
No
Using default
route?
Define IP for
each interface
per port
End
End
Add default
route to
routing table
Configure
RIP version
by port
Enable
global
bridging
Add static
route to
routing table
Using
RIP?