Verilink Net Engine (3150-30626-001) Product Manual - Manual (Page 279)

NetEngine IAD User Guide
Troubleshooting and Diagnostics 260
Using the
Diagnostics
Menu
Diagnostic tasks are all displayed and accessed on the Diagnostics menu
(displayed by typing
Z on the Main menu). Tasks in this chapter are
described beginning at the Diagnostics menu.
Figure 14–1. Diagnostics Menu
You may sign on as Supervisor or Network Manager to perform
diagnostics tasks. Options that display in the Diagnostics menu are the
same for both security levels. Type the option and proceed to the
corresponding section.
POTS
Diagnostics
A WAN uplink is not required to perform POTS testing. To perform POTS
diagnostics type
P on the Diagnostics Menu.
The IAD loads and configures the DSP software module, and displays the
following menu:
Figure 14–2. POTS Diagnostics Menu
*******************************************
Diagnostics Menu
*******************************************
P. POTS Diagnostics
S. SDSL Diagnostics
B. ISDN-BRI Diagnostics
NOTE Option S (SDSL Diagnostics) is available only on SDSL-
equipped IADs: 6300. Option B (ISDN-BRI Diagnostics), is
available only on the 6104i and the 6504i.
*******************************************
POTS Diagnostics
*******************************************
D. Dialup Test
H. Hotline Test
R. Ring Test
S. Power Supply Test
P. Phone Detect Test
R. Ring Test
O. On/Off Hook Test
I. Infineon Codec Test