Verilink Net Engine (3150-30626-001) Product Manual - Manual (Page 120)

NetEngine IAD User Guide
WAN Configuration 101
Enabling or Disabling Coppermountain CMCP
To enable or disable Coppermountain CMCP:
1. On the Main menu, select Configure WAN to display the WAN
Configuration menu.
2. Select Configure FR Options to display the Frame Relay Options menu
(page 97 ).
3. Select Enable/Disable CopperMountain CMCP.
The IAD displays the following instructions.
CMCP is currently DISABLED
Enter E to Enable, D to Disable:
4. Do one of the following:
To enable CopperMountain CMCP, type E .
—or—
To disable CopperMountain CMCP, type
D .
5. Reset the IAD (page 15 ) for changes to take effect.
Toggling CMCP Debugging
Option E (Toggle CMCP Debugging) displays when Coppermountain is
selected as a Gateway, and is reserved for use by Verilink and
Coppermountain network engineers.
This command enables and disables CopperMountain Control Protocol
(CMCP) debugging. You select it once to display the number of
transmitted and received CMCP packets (in bytes). Select it a second time
to disable the display.
NOTE When using a CopperMountain DSLAM, CMCP allows the
DSLAM to configure many IAD parameters automatically.
IAD parameters controlled by CMCP include fragmentation
and voice gateway support. For more information, refer the
CopperMountain DSLAM guide.