Verilink Net Engine (3150-30626-001) Product Manual - Manual (Page 79)

NetEngine IAD User Guide
WAN Configuration 60
Selecting
the
Physical
Interface
On all IADs except the 6500 series, the WAN interface is fixed. On 6500
IADs, you may select G.SHDSL or SDSL as the interface.
1. Type 1 (Configure Physical Interface) to display the G2237 xDSL
Configuration menu.
Figure 4–8. G2237 xDSL Configuration menu
Selecting the xDSL Interface Type
1. Type 1 to display the G2237 xDSL Interface Type menu.
Figure 4–9. G2237 xDSL Configuration menu
Type the option to select G.SHDSL Annex A for operation in U.S.,
Annex B for operation in Europe, or SDSL.
2. The IAD sets the interface type and displays the menu.
3. Press Escape to return to the xDSL Configuration menu.
4. Reset the IAD (page
15 ) when you finish WAN configuration.
LAN LINK LAN ACT WAN LINK VOICE POWER
6504
6504i
6508 This section is for selecting either G.SHDSL or SDSL as the
WAN interface on the 6504, 6504i and 6508.
******************************************
G2237 xDSL Configuration
******************************************
Current Interface Type is: G.SHDSL-A.
Mode: CPE, Rate Mode: FIXED,
Line Rate: 88K, Debug: DISABLED.
1. Select xDSL Interface Type
2. Select CPE/CO Mode
3. Enable/Disable Adaptive Rate Mode
4. Select Line Rate
D. Enable/Disable G2237 xDSL Debug Messages
********************************************
Configure xDSL Interface Type
*******************************************
Current xDSL Interface Type: G.SHDSL
1. G.SHDSL Annex A (U.S.)
2. G.SHDSL Annex B (Europe)
3. SDSL